LEADING LINK FRONT END PICS
 

 

       

       

Close up of installed brake (Washer's will be replaced by machined spacers)
 

Info concerning parts

 

The front wheel was ordered from Jireh Cycles  It is a 19" "Bayonet" (Item # 36-717) and at the time I ordered it, the cost was $439.00.  Not bad for this type of wheel.  The rotor was also ordered from Jireh Cycles (Item 90-901) at a cost of $79.95.   The Brake caliper kit is a GMA 'model B' dual piston brake  ordered from  http://www.jpcycles.com  and had a price of $388.00.  The rod between the brake caliper and tube is a stainless 3/8ths rod and is held in place by two rod end ball joints female series 3/8 - 24.  The braded stainless steel brake line was made for me by a local company Belfair Hyd. hose and fittings for a cost of $60.00.     The fender was ordered off of ebay and the CM-200  shocks were purchased from a motorcycle salvage yard.   I have since replaced the CM-200 shocks with a set of Yamaha Showa 650cc Motorcycle shocks off of ebay.   This stiffened up the front end and makes for a better ride.

 
 

I have a new page on how I built the my Leading Link Front End.  Click on the "next" button to go there.